LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2018 >> Kona Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 148 (Engine Control System Diagnosis - 1.6L (3 Of 3)) >> DTC P1111-00: Cylinder Pressure Too High >> Component Inspection >> Injector Check

Injector Check

WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition switch "OFF".
  2. Remove injectors.
  3. Check leakage or clog on injectors.
  4. Measure the resistance between power and control terminal of the injector. (Component side)

    Specification:  Approx 1.25Ω (20°C (68°F))

    YES 

    • Thoroughly check connectors for looseness, poor connection, ending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "VERIFICATION OF VEHICLE REPAIR ".

    NO 

scientia non olet · About LEMON Manuals