LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2018 >> Kona Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 146 (Engine Control System Diagnosis - 1.6L (1 Of 3)) >> DTC P0130-00: O2 Sensor Circuit (Bank 1 / Sensor 1) >> DTC Information And Inspection >> Monitor DTC Status

Monitor DTC Status

WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.
  1. Plug GDS to Data Link Connector (DLC).
  2. Turn "ON" the ignition switch.
  3. Select "Diagnostic Trouble Codes (DTC)," and click "DTC Status" to check DTC information.
  4. Read the "DTC State" parameter.
  5. Record all DTCs, DTC state and freeze frame data before clearing them. Is the DTC State "Present?"

    YES 

    • Go to next procedure.

    NO 

    • This can be an intermittent fault caused by poor contact of the sensor's and/or ECM (PCM)'s connector. Or, ECM (PCM) memory was not cleared after repair. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace the relevant component(s) as necessary, and go to "VERIFICATION OF VEHICLE REPAIR ".
scientia non olet · About LEMON Manuals