LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2018 >> Kona Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 143 (Blind Spot Collision Warning Diagnosis) >> DTC C2702-54: Left Control Module Missing Calibration >> DTC Information And Inspection >> DTC Detecting Condition

DTC Information And Inspection: DTC Detecting Condition

WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.
Troubleshooting Condition Possible Cause
Main action
  • Monitor the BSD ECU CAN signal
  1. Poor contact of IG wire harness connector
  2. Open/short in wire harness
  3. BSD ECU (LH)
Prerequisite condition
  • Battery voltage is normal
  • 1.5 sec. after turning the ignition switch on
Threshold Value
  • The installation angle of the sensor exceeds the permitted range (correction angle +/- 7.3 degrees)
Diagnosis time
  • 1 sec.
scientia non olet · About LEMON Manuals