LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2018 >> Kona Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 143 (Blind Spot Collision Warning Diagnosis) >> DTC C1812-87: CAN Time-Out Gateway >> DTC Information And Inspection >> DTC Detecting Condition

DTC Information And Inspection: DTC Detecting Condition

WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.
Troubleshooting Condition Possible Cause
Main action
  • Monitor the CAN signal
  1. Poor contact of connector
  2. Open/short in CAN communication circuit
  3. Gateway (IGPM)
Prerequisite condition
  • Battery voltage is normal
  • 1.5 sec. after turning the ignition switch on
  • Engine is running
  • Turn on the BSD switch
  • CAN Bus-off DTC (C1616-88) is not detected
Threshold Value
  • AT vehicle (Automatic Transmission): Normal operation (no secondary alert)
  • MT vehicle (Manual Transmission): Inhibit an alert at the rear right and left sides
Diagnosis time
  • after 0.5 sec.