C-CAN Terminal Inspection
WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.
| Item | Normal value | Prerequisite condition | Probe (+) | Probe (-) |
|---|---|---|---|---|
| CAN Communication Circuit: resistance | Approx. 60Ω | 1. Ignition switch: OFF | EPS CAN High terminal | EPS CAN Low terminal |
| Approx. 120Ω | 1. Ignition switch: OFF 2. PCM, cluster connector: Disconnected |
PCM CAN High terminal | PCM CAN Low terminal |
- Is the result within specifications?
YES
- Fault can be intermittent, caused by poor contact of connector or wire harness. Or, the control module's memory was not cleared after repair. Thoroughly check connectors for looseness, poor contact, bending, corrosion, deterioration, or damage.
- Repair or replace relevant component(s) as necessary and then go to "VERIFICATION OF VEHICLE REPAIR ".
NO
- Go to next procedure.