LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2018 >> Kona Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 142 (Automatic Transaxle System Diagnosis - 2.0L) >> DTC P0601-00: Internal Control Module Memory Check Sum Error >> DTC Information And Inspection >> Monitor DTC Status

Monitor DTC Status

WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.
  1. Plug GDS to Data Link Connector (DLC).
  2. Turn "ON" the ignition switch.
  3. Select "Diagnostic Trouble Codes (DTC)," and click "DTC Status" to check DTC information.
  4. Read the "DTC State" parameter.
  5. Clear recorded DTC using GDS.
  6. Ignition switch OFF → Ignition switch ON 2~3 times and Select "Diagnostic Trouble Codes (DTCs)"mode and monitor "DTC Status" parameter.
  7. Is the DTC State "Present?"

    "PRESENT" 

    • PCM/TCM's ROM or DATA is changed by reprogram illegally.
    • Substitute with a known-good PCM/TCM and check for proper operation. If the problem is corrected, replace PCM/TCM and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    "HISTORY" 

scientia non olet · About LEMON Manuals