LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2018 >> Kona Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 140 (Anti-Lock Brake System (Abs)/Electronic Stability Control (ESC) Diagnosis) >> DTC C1613-08: CAN Signal Error EMS >> Component Inspection >> Engine System Diagnosis

Engine System Diagnosis

WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect GDS and select "Diagnostic Trouble Codes (DTCs)" mode.
  2. Turn "ON" the Ignition Switch.
  3. Using GDS, check if there is an error in Engine system.
  4. Are any DTCs present?

    YES 

    • This DTC appears when the CAN messages from PCM (ECM) is invalidate.
    • Repair the vehicle according to the engine system service guide.

    NO 

    • Fault can be intermittent, caused by poor connection in power harness (Ignition +) and/or ESP (ESC)'s connector. Or, ESP (ESC) memory was not cleared after repair. Go to "VERIFICATION OF VEHICLE REPAIR " procedure.
scientia non olet · About LEMON Manuals