LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2018 >> Kona Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 140 (Anti-Lock Brake System (Abs)/Electronic Stability Control (ESC) Diagnosis) >> DTC C1208-02: Wheel Speed Sensor Rear-LH Invalid/No Signal >> DTC Information And Inspection >> GDS Data Analysis

GDS Data Analysis

WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the Ignition Switch "ON".
  2. Connect GDS to Data Link Connector (DLC).
  3. Start and drive vehicle in gear and maintain vehicle speed at or above 10km/h. (6.2 mi/h).
  4. Monitor the "wheel Speed Sensor" parameter on the "Current Data" menu of the GDS.

    Specification:  Compare with other parameters related to Wheel Speed Sensor. If it is the same as other parameters, it is in normal condition.

  5. Is the result within specifications?

    YES 

    • Fault can be intermittent, caused by poor connection. Or, ESP (ESC) memory was not cleared after it was repaired. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO 

    • Go to next step.
scientia non olet · About LEMON Manuals