LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2018 >> Kona Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 140 (Anti-Lock Brake System (Abs)/Electronic Stability Control (ESC) Diagnosis) >> DTC C1207-02: Wheel Speed Sensor Rear-LH Range/Performance/Intermittent >> DTC Information And Inspection >> Monitor DTC Status

Monitor DTC Status

WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.
  1. Plug GDS to Data Link Connector (DLC).
  2. Turn "ON" the Ignition Switch.
  3. Select "Diagnostic Trouble Codes (DTC)," and click "DTC Status" to check DTC information.
  4. Read the "DTC State" parameter.
  5. Record all DTCs, DTC state and freeze frame data. Is the DTC State "Present?"
    NOTE:
    • History (Not Present) state: the DTC set but has been cleared.
    • Present state: the DTC is active at present time.

    YES 

    • Go to next procedure.

    NO 

    • Fault can be intermittent, caused by poor connection in Wheel Speed Sensor harness. Or, ESP (ESC) memory was not cleared after it was repaired. Go to "VERIFICATION OF VEHICLE REPAIR " procedure.
scientia non olet · About LEMON Manuals