LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2018 >> Kona Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Engine Control System - 2.0L) >> Knock Sensor (KS) >> Repair Procedures >> Inspection >> Component Inspection

Component Inspection

WARNING: This page is about a different car, the 2021 Kia Seltos. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition switch OFF.
  2. Disconnect the knock sensor connector.
  3. Measure resistance between the knock sensor terminals 1 and 2.
  4. Check that the resistance is within the specification.

    Specification  : Approximately. 4.87 MΩ [20°C (68°F)]

scientia non olet · About LEMON Manuals