Main Harness Circuit Inspection
WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.
| Item | Normal Value | Prerequisite Condition | Probe (+) | Probe (-) |
|---|---|---|---|---|
| Main harness Circuit Inspection (Ω) | Below 1Ω |
|
"Low" terminal of the Buckle Switch Passenger harness connector. | "Low" terminal of the SRSCM harness connector. |
| "High" terminal of the Buckle Switch Passenger harness connector. | "High" terminal of the SRSCM harness connector. |
- Is the measured signal waveform normal?
YES
- Go to "MAIN HARNESS CIRCUIT INSPECTION " procedure.
NO
- Substitute the SRSCM main harness and check for proper operation.
If the problem is corrected, replace SRSCM main harness and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
| Item | Normal Value | Prerequisite Condition | Probe (+) | Probe (-) |
|---|---|---|---|---|
| Main harness Circuit Inspection (V) | 0V |
|
"Low" terminal of the Buckle Switch Passenger harness connector. | Chassis ground |
| "High" terminal of the Buckle Switch Passenger harness connector. |
- Is the measured resistance within specifications?
YES
- Go to "COMPONENT INSPECTION " procedure.
NO
- Substitute the SRSCM main harness and check for proper operation.
If the problem is corrected, replace SRSCM main harness and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.