LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2018 >> Kona Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 137 (Airbag System Diagnosis (1 Of 2)) >> DTC B1475-00: Inflatable Curtain Airbag Driver Resistance Circuit Short To Ground >> DTC Information And Inspection >> Monitor GDS Data

Monitor GDS Data

WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition "OFF", connect GDS.
  2. Ignition "ON"& Engine "OFF", select "Current Data" mode.
  3. Monitor the "Curtain Airbag Front-Driver Resistance" parameter on the GDS.

    Specification:  Resistance of curtain airbag front-Driver is between 1.0Ω and 6.9Ω

    Reference: 

    In a case of an open in the curtain airbag Front-Driver circuit: FAIL

    In a case of a short to battery in the curtain airbag Front-Driver circuit: FAIL

    In a case of a short to ground in the curtain airbag Front-Driver circuit: FAIL

    G12595952Courtesy of HYUNDAI MOTOR AMERICA
  4. Is parameter displayed within specifications?

    YES 

    • Displaying nothing (no DTC) or DTC with label "H"(Historical) shows that Fault is intermittent caused by poor contact in the part's and/or SRSCM connector or was repaired and SRSCM memory was not cleared.
    • Thoroughly check shorting bar/shorting bar release pin and connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.
    • Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO 

scientia non olet · About LEMON Manuals