Component Inspection

WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.

Ignition "ON" & Engine "OFF" and Using a GDS, clear the DTC.
Ignition "OFF".
Disconnect the battery (-) terminal cable from the battery, and wait at least one minutes.
Disconnect DSIS connector.
Substitute the DSIS and check for proper operation.
Is DTC present problem?
YES
- Substitute a known-good SRSCM, and check for proper operation.
  If the problem is corrected, replace SRSCM and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
- Substitute the SRSCM main harness and check for proper operation.
  If the problem is corrected, replace SRSCM main harness and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Substitute a known-good DSIS, and check for proper operation.
  If the problem is corrected, replace DSIS and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.