Wire Harness Inspection
WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.
| Item | Normal Value | Prerequisite Condition | Probe (+) | Probe (-) |
|---|---|---|---|---|
| Control circuit (Open): resistance | Approx. below 1Ω | A/C Control Module, Intake actuator connector: Disconnected Ingestion switch: OFF |
Intake actuator harness' motor (+) terminal | Intake actuator motor (+) terminal attached to A/C Control Module harness |
| Intake actuator harness' motor (-) terminal | Intake actuator motor (-) terminal attached to A/C Control Module harness | |||
| Control circuit (Short): resistance | Infinite | Intake actuator connector: Disconnected Ingestion switch: OFF |
Intake actuator harness' motor (+) terminal | Chassis ground |
| Intake actuator harness' motor (-) terminal | Chassis ground |
- Is the result within specifications?
YES
- Go to next procedure.
NO
- Repair an open or short in the Control Circuit. Then go to "VERIFICATION OF VEHICLE REPAIR ".