Actuator Potentiometer Inspection
WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.
| Item | Normal Value | Prerequisite Condition | Probe (+) | Probe (-) |
|---|---|---|---|---|
| Signal Circuit: Voltage | Refer to FIG 1 | A/C Control Module, driver seat temperature actuator connector: Connected Ignition switch: ON |
Driver seat temperature actuator's signal terminal | Sensor ground |
(FIG.1)
| Actuator Position | Voltage |
|---|---|
| Max. COOL | 0.3 ± 0.15V |
| Max. WARM | 4.7 ± 0.15V |
Fig. 1 * Voltage of the Driver Seat Temperature Actuator by setting
- Is the result within specifications?
YES
- Check Wire Harness for contact condition. Then go to "VERIFICATION OF VEHICLE REPAIR ".
NO
- Replace the Driver Seat Temperature Actuator with an usable one and check for proper operation. If it works properly, put the new actuator in place.
- Repair or replace relevant component (s) as necessary and then go to "VERIFICATION OF VEHICLE REPAIR ".