Wire Harness Inspection
WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.
| Item | Normal Value | Prerequisite Condition | Probe (+) | Probe (-) |
|---|---|---|---|---|
| Power Circuit (Open): Resistance | Approx. below 1Ω | A/C Control Module, Electric A/C Valve connector: Disconnected Ingestion switch: OFF |
Electric A/C Valve harness' power terminal | Electric A/C Valve's power terminal attached to A/C Control Module harness |
| Ground circuit (Open): resistance | Electric A/C Valve harness' ground terminal | Electric A/C Valve's ground terminal attached to A/C Control Module harness |
- Is the result within specifications?
YES
- Fault is intermittent caused by poor contact of connectors or wire harness. Or, the control module's memory was not cleared after repair. Thoroughly check connectors for looseness, poor connection, bending, corrosion, deterioration, or damage.
- Repair or replace relevant component (s) as necessary and then go to "VERIFICATION OF VEHICLE REPAIR ".
NO
- Repair an open in the circuits. Then go to "VERIFICATION OF VEHICLE REPAIR ".