Wire Harness Inspection
WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.
| Item | Normal Value | Prerequisite Condition | Probe (+) | Probe (-) |
|---|---|---|---|---|
| Signal Circuit (Short): Voltage | Approx. 0V | A/C Control Module, Auto Defog Sensor connector: Disconnected Ignition switch: ON |
Auto Defog Sensor harness' signal terminal | Chassis ground |
| Signal circuit (Open): resistance | Approx. below 1Ω | A/C Control Module, Auto Defog Sensor connector: Disconnected Ignition switch: OFF |
Auto Defog Sensor harness' signal terminal | Auto Defog Sensor's signal terminal attached to A/C Control Module harness |
- Is the result within specifications?
YES
- Go to next procedure.
NO
- Repair an open/short in the signal circuit. Then go to "VERIFICATION OF VEHICLE REPAIR ".