Wire Harness Inspection
WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.
| Item | Normal Value | Prerequisite Condition | Probe (+) | Probe (-) |
|---|---|---|---|---|
| Power circuit (Open/Short): voltage | Approx. 5V | Driver seat temperature actuator connector: Disconnected Ignition switch: ON |
Driver seat temperature actuator's power terminal | Chassis ground |
| Signal circuit (Short): resistance | Infinite | Driver seat temperature actuator connector: Disconnected Ignition switch: OFF |
Driver seat temperature actuator's signal terminal | Chassis ground |
| Signal circuit (Open): resistance | Approx. below 1Ω | A/C Control Module, driver seat temperature actuator connector: Disconnected Ignition switch: OFF |
Driver seat temperature actuator's signal terminal | Driver seat temperature actuator's signal terminal attached to A/C Control Module |
- Is the result within specifications?
YES
- Go to next procedure.
NO
- Repair an open/short in the signal circuit and power circuit or an open in the ground circuit. Then go to "VERIFICATION OF VEHICLE REPAIR ".