Evaporator Sensor Component Inspection
WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.
| Item | Normal Value | Prerequisite Condition | Probe (+) | Probe (-) |
|---|---|---|---|---|
| Component Resistance | Refer to FIG 1 | Evaporator sensor connector: Disconnected Ignition switch: OFF |
Evaporator sensor's signal terminal | Evaporator sensor's ground terminal |
(FIG.1)
| Temperature (°C) | Resistance (kΩ) | Temperature (°C) | Resistance (kΩ) |
|---|---|---|---|
| -10 | 43.3 | 20 | 12.1 |
| 0 | 27.6 | 30 | 8.3 |
| 10 | 18 | 40 | 5.8 |
Fig. 1 * Resistance of the evaporator sensor by temperature
- Is the result within specifications?
YES
- Go to next procedure.
NO
- Replace the Evaporator Sensor with an usable one and check for proper operation. If it works properly, put the new ambient temperature sensor in place.
- Repair or replace relevant component (s) as necessary and then go to "VERIFICATION OF VEHICLE REPAIR ".