Monitor Current Data
WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.
- Connect GDS to Data Link Connector (DLC).
- Turn the ignition switch ON and warm up the vehicle up to an operational temperature.
- Select "In-car Temperature Sensor - Front" parameter on the "Current Data" of the GDS.
- Is there a DTC?
YES
- Since the In-Car Temperature Sensor is installed inside the A/C Control Panel, replace the A/C Control Module (HEATER AND A/C CONTROL UNIT ) with an usable one and check for proper operation. If it works properly, put the new component in place.
- Repair or replace relevant component (s) as necessary and then go to "VERIFICATION OF VEHICLE REPAIR ".
NO
- Fault is intermittent caused by poor contact of the component's and/or control module's connector. Thoroughly check connectors for looseness, poor connection, bending, corrosion, deterioration, or damage.
- Repair or replace relevant component (s) as necessary and then go to "VERIFICATION OF VEHICLE REPAIR ".