Wire Harness Inspection
WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.
| Item | Normal Value | Prerequisite Condition | Probe (+) | Probe (-) |
|---|---|---|---|---|
| Signal circuit (Short): voltage | Approx. 0V | Intake actuator connector: Disconnected Ignition switch: ON |
Intake actuator harness' signal terminal | Chassis ground |
| Ground circuit (Open): resistance | Approx. below 1Ω | A/C Control Module, Intake actuator connector: Disconnected Ignition switch: OFF |
Intake actuator harness' ground terminal | Intake actuator's ground terminal attached to A/C Control Module harness |
- Is the result within specifications?
YES
- Go to next procedure.
NO
- Repair an open/short in the power circuit or signal circuit. Then go to "VERIFICATION OF VEHICLE REPAIR ".