Monitor DTC Status
WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.
- Plug GDS to Data Link Connector (DLC).
- Turn "ON" the ignition switch.
- Select "Diagnostic Trouble Codes (DTC)", and click "DTC Status" to check DTC information.
- Read the "DTC State" parameter.
- Is the DTC State "Present"?
"PRESENT"
- After clearing the DTC, check the operational state of the ANTI-LOCK BRAKE SYSTEM (ABS) Wheel Sensor before and after.
- Put a tire in place and check for a slip.
HISTORY"
- This can be an intermittent fault caused by poor contact of the connector or wire harness. Or, the control module's memory was not cleared after repair. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.
- Repair or replace the relevant component(s) as necessary, and go to "VERIFICATION OF VEHICLE REPAIR ".