Repair Procedures: Replacement

WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Put on gloves to prevent hand injuries.

Information

When Removing With A Flat-Tip Screwdriver Or Remover, Wrap Protective Tape Around The Tools To Prevent Damage To Components.
Use a plastic panel removal tool to remove interior trim pieces without marring the surface.
Take care not to bend or scratch the trim and panels.

Remove the cowl side trim.
(Refer to Interior Trim - "COWL SIDE TRIM ")
Remove the glover box.
(Refer to Crash Pad - "GLOVE BOX ")
Remove the crash pad garnish assembly [RH]
(Refer to Crash Pad - "CRASH PAD GARNISH ASSEMBLY [RH] ")
After loosening the mounting screws, nut and bolts, remove the glove box housing cover (A).

Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the glove box lamp connector (A) and the lamp switch connector (B).

Courtesy of HYUNDAI MOTOR AMERICA

Courtesy of HYUNDAI MOTOR AMERICA
To install, reverse removal procedure.
Information
- Make sure the connector are connected in properly.
- Replace any damaged clips (or pin-type retainers).