Deploying The Airbag Out Of The Vehicle

In case the airbag is separated from a scrapped car, or when you find defects or damages on it, you have to deploy it as follows:

1. Place the airbag deployment module face upward on a flat surface outdoor.
   WARNING:

   • If the airbag deployment module were face downward, the airbag will pop up and cause damage to people around it.
2. Get ready to deploy the airbag as follows:
   1. Separate the 2-pin connector of the airbag from the vehicle.
   2. Connect the deployment adapter.
      • For the driver airbag, separate the 2-pin connector from it and connect the deployment adapter to reattach it on the steering wheel.
3. Locate the airbag deployment tool at a place at least 5 meters away from the airbag.
4. After connecting the deployment adapter (0957A-AL140, 0957A-AL120) with the deployment tool (0957A-34100A), connect it to the external battery (12V) for deployment.
   1. Battery (12V)
   2. Airbag Deploy (0957A-34100A)
   3. Deployment adapter
      • DAB, PAB, CAB, BPT (0957A-AL140)
      • SAB (0957A-AL120)

      Courtesy of HYUNDAI MOTOR AMERICA

   CAUTION:

   • When EFD are deployed, broken parts are exploded and scattered.
   • EFD (Emergency Fastening Device) must be placed in the piled up 5 tires to avoid exploded broken parts.
   • Technicians should wear an eye protector and extremely be cautions of exploded broken parts.
5. Switch on the deployment tool to proceed with deployment.
   1. If the battery is connected, the POWER ON (1) light will be on.
   2. Press and hold READY (2) until it is on, and then press DEPLOY (3) to deploy the airbag.

   Courtesy of HYUNDAI MOTOR AMERICA

6. Dispose of the complete airbag. No parts can be reused. Place it in a sturdy plastic bag and seal it securely.

   Courtesy of HYUNDAI MOTOR AMERICA