LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2018 >> Kona Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 131 (Airbag Modules And Clock Spring) >> Airbag Module Disposal >> Description And Operation >> Airbag Disposal >> Deploying Airbags In The Vehicle

Deploying Airbags In The Vehicle

WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition switch OFF, and disconnect the battery negative cable and wait at least three minutes.
  2. Confirm that each airbag or side airbag is securely mounted.
  3. Confirm that the special tool is functioning properly by following the check procedure.
    1. Disconnect the 2P connector between the airbag and wire harness.
    2. Install the SST
      • For the driver airbag, separate the 2-pin connector from it and connect the deployment adapter to reattach it on the steering wheel.
  4. Locate the airbag deployment tool at a place at least 5 meters away from the airbag.
  5. After connecting the deployment adapter with the deployment tool (0957A-34100A), connect it to the external battery for deployment.
    1. Battery (12V)
    2. Deployment tool (0957A-34100A)
    3. Deployment adapter
      • DAB, PAB, CAB, BPT (0957A-AL140)
      • SAB (0957A-AL120)
    G12602550Courtesy of HYUNDAI MOTOR AMERICA
  6. Switch on the deployment tool to proceed with deployment.
    1. If the battery is connected, the POWER ON (1) light will be on.
    2. Press and hold READY (2) until it is on, and then press DEPLOY (3) to deploy the airbag.
    G12602551Courtesy of HYUNDAI MOTOR AMERICA
    NOTE:
    • Upon deployment, the airbag will create a loud noise and you can see it suddenly expand and contract slowly.
  7. Dispose of the complete airbag. No parts can be reused. Place it in a sturdy plastic bag and seal it securely.
    G12602552Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals