LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2018 >> Kona Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 129 (Electronic Stability Program (Esp) System) >> Troubleshooting >> Failure Diagnosis >> When Ignition Key Is Turned ON (engine OFF), The ABS Warning Lamp Does Not Light Up >> Inspection Procedures >> Problem Verification

Problem Verification

WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the connector from the ABS control module and turn the ignition switch ON.
  2. Does the ABS warning lamp light up?

    YES 

    • Inspect again after replacing the ABS HECU.

    NO 

    • Check the power source for the ABS warning lamp.
scientia non olet · About LEMON Manuals