LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2018 >> Kona Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 129 (Electronic Stability Program (Esp) System) >> Troubleshooting >> Failure Diagnosis >> Even After The Engine Is Started, The ABS Warning Lamp Remains ON >> Check The CAN Circuit Resistance For ABS Warning Lamp

Check The CAN Circuit Resistance For ABS Warning Lamp

WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the instrument cluster connector (M08) and turn the ignition switch OFF.
  2. Measure the resistance between terminal (M08) 32 and 33 of the cluster harness side connector.

    Specification:  60Ω

  3. Is resistance within specification?

    YES 

    • Repair ABS warning lamp bulb or instrument cluster assembly.

    NO 

    • Check the CAN circuit wiring for ABS warning lamp.
    G12602822Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals