LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2018 >> Kona Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 128 (Engine Control System - 2.0L) >> Variable Intake Solenoid (VIS) Valve >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Disconnect the variable intake solenoid valve connector (A).
  3. Disconnect the vacuum hoses (B) from the valve.
  4. Remove the installation bolt (C), and then remove the valve from the surge tank.
    G12606938Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals