LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2018 >> Kona Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 128 (Engine Control System - 2.0L) >> Camshaft Position Sensor (CMPS) >> Repair Procedures >> Removal >> Bank 1/Exhaust

Bank 1/Exhaust

WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Disconnect the camshaft position sensor connector (B) after removing the clip (A).
  3. Remove the installation bolt (C), and then remove the sensor.
    G12606903Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals