Repair Procedures: Removal

WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the negative (-) battery terminal.
Remove the rear bumper.
(Refer to Body - "REAR BUMPER ")
Remove the BCW unit after loosening the mounting nuts.
[LH]

Courtesy of HYUNDAI MOTOR AMERICA

[RH]

Courtesy of HYUNDAI MOTOR AMERICA
NOTE:
- Take care not to separate the bracket from rear bumper when removing the BCW sensor.
Replace the bracket (A) when the bracket is physically changed or damaged.

Courtesy of HYUNDAI MOTOR AMERICA
CAUTION:
- Radar does not work normally if the bracket is physically changed or damaged.
Replace the extension wiring (A) when it damaged.

Courtesy of HYUNDAI MOTOR AMERICA