Monitor DTC Status
WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.
- Plug GDS to Data Link Connector (DLC).
- Turn "ON" the Ignition Switch.
- Select "Diagnostic Trouble Codes (DTC)," and click "DTC Status" to check DTC information.
- Read the "DTC State" parameter.
- Is the DTC State "Present?"
"PRESENT"
- Replace the EPS ECU with an usable one and check for normal operation. If it works properly, put it in place. Before replacement, refer to (MOTOR DRIVEN POWER STEERING (MDPS) SYSTEM ) "GDS -> Optional Function -> Component Replacement (ECU Replacement)".
"HISTORY"
- The memory was not cleared after repair. Clear the DTC and go to "VERIFICATION OF VEHICLE REPAIR ".