LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2018 >> Kona Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 122 (Dual Clutch Transmission Control System - 1.6L) >> Input Shaft Speed Sensor 1 >> Repair Procedures >> Installation

Repair Procedures: Installation

WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.
  1. To install, reverse the removal procedure.
    NOTE:
    • Before installing the input speed sensor, check the assembled state of the O-rings (A) and should apply gear oil to the surface of O-rings.
    G12596914Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals