Repair Procedures: Removal
WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the air cleaner assembly and air duct.
(Refer to Engine Mechanical System - "AIR CLEANER ")
- Remove the battery and battery tray.
(Refer to Engine Electrical System - "BATTERY ")
- Remove the ECM.
(Refer to Engine Control System - "ENGINE CONTROL MODULE (ECM) ")
- Disconnect the gear actuator solenoid connector (A).
- Disconnect the gear actuator motor connector (A).
- Separate the wiring harness (A) after loosening the bolt.
- Remove The Gear Actuator Assembly After Loosening The Bolts (A-2Ea, B-3Ea).
Tightening Torque
(A): 9.8 - 11.8 N.m (1.0 - 1.2kgf.m, 7.2 - 8.7 lb-ft)
(B): 19.6 - 26.5 N.m (2.0 - 2.7kgf.m, 14.5 - 19.5 lb-ft)