LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2018 >> Kona Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 120 (Engine Control System - 1.6L) >> Electric WGT Control Actuator >> Repair Procedures >> Inspection

Repair Procedures: Inspection

WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.

[Motor] 

  1. Turn ignition switch OFF.
  2. Disconnect the EWGA connector.
  3. Check that the EWGA is stuck by foreign material.
  4. Measure resistance between motor (+) and (-) control terminals of the motor.
  5. Check that the resistance is within the specification.

    Specification:  Refer to "SPECIFICATION "

[Position Sensor] 

  1. Turn ignition switch OFF.
  2. Connect the GDS to the Data Link Connector (DLC).
  3. Check the output voltage at each position of the EWGA position sensor on current data part within the specification.

    Specification:  Refer to "SPECIFICATION "

scientia non olet · About LEMON Manuals