Repair Procedures: Installation

WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.

Installation is in the reverse order of removal.

Perform the following:

Adjust a shift cable.
Refill engine with engine oil.
Refill a transaxle with fluid.
Refill a radiator and a reservoir tank with engine coolant.
Inspect for fuel leakage.

After assemble the fuel line, turn on the ignition switch (do Not operate the starter) so that the fuel pump runs for approximately two seconds and fuel line pressurizes.
Repeat this operation two or three times, then check for fuel leakage at any point in the fuel line.

Place a heater control knob on "HOT" position.
Bleed air from the cooling system.

Start engine and let it run until it warms up. (until the radiator fan operates 3 or 4 times.)
Turn off the engine. Check the level in the radiator, add coolant if needed. This will allow trapped air to be removed from the cooling system.

Clean battery posts and cable terminals and assemble.