LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2018 >> Kona Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 111 (Front Bumper And Radiator Grille) >> Radiator Grille >> Repair Procedures >> Replacement

Repair Procedures: Replacement

WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Put on gloves to prevent hand injuries.
NOTE:
  • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
  • Use a plastic panel removal tool to remove interior trim pieces without marring the surface.
  • Take care not to bend or scratch the trim and panels.
  1. Remove the front bumper cover.

    (Refer to Front Bumper - "FRONT BUMPER COVER ")

  2. Remove the front bumper energy absorber (A).
    G12605292Courtesy of HYUNDAI MOTOR AMERICA
  3. After loosening the mounting screws, remove the front bumper upper cover (A).
    G12605293Courtesy of HYUNDAI MOTOR AMERICA
  4. After loosening the mounting screws, remove the radiator grill (A).
    G12605294Courtesy of HYUNDAI MOTOR AMERICA
  5. To install, reverse removal procedure.

    Information 

    • Replace any damaged clips (or pin-type retainers).
scientia non olet · About LEMON Manuals