Component Inspection
WARNING: This page is about a different car, the 2021 Kia Seltos. However, it is still accessible from the selected car via links, so may be relevant.
| Inspection Condition | (+) Probe | (-) Probe | Specification | ||
|---|---|---|---|---|---|
| Connector | Terminal | Connector | Terminal | ||
|
BLS connector | 4 (Memory power) | BLS connector | 5 (stop lamp signal) | ∞ (infinity)Ω |
| BLS connector | 1 (ON/START Input) | BLS connector | 2 (stop signal) | Approx. below 1Ω | |
|
BLS connector | 4 (Memory power) | BLS connector | 5 (stop lamp signal) | Approx. below 1Ω |
| BLS connector | 1 (ON/START Input) | BLS connector | 2 (stop signal) | ∞ (infinity)Ω | |
Good
- Fault might be intermittent and caused either by poor contact in connectors or wiring harness, or it has been repaired and control module memory is not cleared yet. Thoroughly check terminal of battery, all connectors (and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage.
- Repair or replace as necessary and then go to "VERIFICATION OF REPAIR " procedure.
No Good
- Carefully re-do this troubleshooting guide steps.
- If no problems were found with the circuits or connectors, replace BLS and then go to "VERIFICATION OF REPAIR " procedure.