DTC Information: DTC Detecting Condition
WARNING: This page is about a different car, the 2021 Kia Seltos. However, it is still accessible from the selected car via links, so may be relevant.
| Item |
Detecting Condition |
Possible Cause |
| DTC Strategy |
|
- Poor connector connection
- Open or short in master pressure sensor circuit
- Faulty HECU (pressure sensor integrated)
|
| Enable Condition |
- Normal battery voltage (9 to 16V)
|
| Threshold Value |
- A failure is detected when sensor supply voltage is below 4.75V or above 5.25V for more than 0.06s
- When pressure sensor signal is not received for more than 0.45s
- A failure is detected when the pressure sensor output is below -12bar or above 262bar for more than 0.45s
- A failure is detected If sum of the sensor values keep below 230bar or above 291bar for more than 0.45s
- When pressure sensor channels 1 and 2 Internal status is abnormal for more than 0.45s
- When pressure sensor fast/slow channel checksum error status is abnormal for more than 450ms
- A failure is detected when the pressure sensor output temperature is below -60°C (-76°F) or above 160°C (320°F) for more than 0.45s
|
| Warning Lamp |
|
| Disable Condition |
- When the ignition switch turns off and then on
|