DTC Information: DTC Detecting Condition
WARNING: This page is about a different car, the 2021 Kia Seltos. However, it is still accessible from the selected car via links, so may be relevant.
| Item |
Detecting Condition |
Possible Cause |
| DTC Strategy |
|
- Poor connector connection
- Large air gap
- Faulty signal circuit of WSS FL
- Faulty WSS FL
|
| Enable Condition |
|
| Threshold Value |
Case1 |
- When the vehicle speed is greater than 12 kph (7.4 mph), if an arbitrary wheel speed is sensed under 1.6 kph (1.0 mph) for more than 1s
- A failure is detected when the vehicle speed is greater than 18 kph (11.1 mph), if front left wheel speed is sensed under 1.6 kph (1.0 mph)
|
| Case2 |
- If the wheel speed difference is greater than the threshold value on one of the wheels
- FL/RL, FR/RR: 6 to 12 kph (3.7 to 7.4 mph)
FL/FR: 10 to 16 kph (6.2 to 12.4 mph), fault detection time is 20s
- FL/RL, FR/RR: Higher than 12 kph (7.4 mph)
FL/FR: Higher than 16 kph (12.4 mph), fault detection time is 10s
- When spin occurs on front wheel, fault detection time is maximum 80s
|
| Case3 |
- Stand still pulse is not received for more than 2.5s
- Invalid pulse is received for more than 0.25s
|
| Warning Lamp |
Only one wheel failure |
|
| Two or more wheels failure |
|
| Disable Condition |
- When all wheel speed is normal after driving more than 12 kph (7.45 mph) after the ignition switch turns off and then on
|