Verification Of Repair

WARNING: This page is about a different car, the 2021 Kia Seltos. However, it is still accessible from the selected car via links, so may be relevant.

After a repair, it is essential to verify that the fault has been corrected.

Connect KDS/GDS to "Data Link Connector (DLC)", and monitor "Diagnostic Trouble Codes (DTC)".
Clear all DTCs in the system with KDS/GDS.
Operate system or vehicle within DTC detecting condition in "DTC Detecting Condition" chart.
Monitor "Diagnostic Trouble Codes (DTC)" with KDS/GDS and verify that any DTC is stored.
Verify that the DTC is cleared and system operates correctly.

Good

Problem is corrected and the system operation performs to specification at this time.

No Good

Go to applicable troubleshooting procedure.