Repair Procedures: Replacement

CAUTION:

NOTE:

When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
Use a plastic panel removal tool to remove interior trim pieces without marring the surface.
Take care not to bend or scratch the trim and panels.

Loosen the pin-type retainers and bolts of the front bumper upper.

Courtesy of HYUNDAI MOTOR AMERICA
Loosen the front bumper lower mounting clips.

Courtesy of HYUNDAI MOTOR AMERICA
After loosening the pin-type retainers and screws on the side of front bumper (A), detach the side part of front bumper.
CAUTION:
- When you pull out the front bumper, the side part of the front bumper could be damaged by the projection.
Courtesy of HYUNDAI MOTOR AMERICA
Remove the front bumper cover (A).

Courtesy of HYUNDAI MOTOR AMERICA
To install, reverse removal procedure.
Information
- Make sure the connector is plugged in properly.
- Replace any damaged clips (or pin-type retainers).