Monitor DTC Status
- Plug GDS to Data Link Connector (DLC).
- Turn "ON" the ignition switch.
- Select "Diagnostic Trouble Codes (DTC)," and click "DTC Status" to check DTC information.
- Read the "DTC State" parameter.
- Is the DTC State "Present?"
"PRESENT"
- If the same DTC returns, replace the BSD ECU with an normal test sample and check for proper operation. If the problem is corrected, replace the BSD ECU and go to "VERIFICATION OF VEHICLE REPAIR ".
"HISTORY"
- The memory was not cleared after repair. Clear the DTC and go to "VERIFICATION OF VEHICLE REPAIR ".