Power Circuit And Ground Circuit Inspection
| Item | Normal value | Prerequisite condition | Probe(+) | Probe(-) |
|---|---|---|---|---|
| Power circuit (open/short): voltage | Battery voltage | 1. BSD switch connector: Disconnected 2. Ignition switch: Engine "ON". |
BSD switch power terminal | Chassis ground |
| Ground circuit (open): resistance | Below 0.1Ω | 1. BSD switch connector: Disconnected 2. Ignition switch: OFF |
BSD switch ground terminal | Chassis ground |
- Is the result within specifications?
YES
- Replace the BSD switch assembly with an usable one. If the BSD switch assembly works properly, replace the mirror and go to "VERIFICATION OF VEHICLE REPAIR ".
NO
- Inspect the power connector and check for an open/short in wire harness.
- Repair relevant component(s) as necessary and then go to "VERIFICATION OF VEHICLE REPAIR ".