Removal And Installation

Remove the air duct and air cleaner assembly.
(Refer to "AIR CLEANER ")
Remove the intercooler outlet hose (A).
Tightening torque:

4.9 ~ 6.8 N.m (0.5 ~ 0.7 kgf.m, 3.6 ~ 5.0 lb-ft)

Fig 1: Locating Intercooler Outlet Hose
Courtesy of HYUNDAI MOTOR AMERICA
Remove the intercooler inlet hose & pipe (A).
Tightening torque

Bolt:

19.6 ~ 26.4 N.m (2.0 ~ 2.7 kgf.m, 14.4 ~ 19.5 lb-ft)

Clamp:

4.9 ~ 6.8 N.m (0.5 ~ 0.7 kgf.m, 3.6 ~ 5.0 lb-ft)

Fig 2: Locating Intercooler Inlet Hose & Pipe (1 Of 2)
Courtesy of HYUNDAI MOTOR AMERICA

Fig 3: Locating Intercooler Pipe Clamp (2 Of 2)
Courtesy of HYUNDAI MOTOR AMERICA
Install in the reverse order of removal.
NOTE:
- Match the marking part of hose and marking part of throttle body, compressor.
- Match the pipe stopper and hose marking.
- When the band part have been place on the top of position mark of hose, install to not exceed the mark.
- Tighten until the torque control cap is released. If there is no the torque control cap, tighten as specified torque.