Air Bleeding Tool Installation Procedure

CAUTION: To prevent the brake fluid reservoir tank from being damaged and ensure the safety of worker, set the pressure of the gauge to the standard value before installing the SST.

Before installing the SST on the vehicle, close the air shut-off valve (A) to adjust the pressure gauge to the standard value.

Fig 1: Closing Air Shut-Off Valve
Courtesy of HYUNDAI MOTOR AMERICA

CAUTION: For safety of worker and correct pressure setting, make sure that the plug (B) is installed correctly.
After connecting an air hose and opening the air shut-off valve (A), adjust the pressure gauge (B) with to the standard value.
Standard pressure value : 0.3 ~ 0.5MPa (43.5 ~ 72.5psi)

Fig 2: Opening Air Shut-Off Valve
Courtesy of HYUNDAI MOTOR AMERICA
close the air shut off valve (A) and remove the plug (B).

Fig 3: Closing Air Shut Off Valve
Courtesy of HYUNDAI MOTOR AMERICA

CAUTION: For safety of worker, make sure that the air shut off valve is closed and remove the plug.
Remove the brake reservoir tank cap.
Install the cap (A) of SST (0k585-E8100) on the reservoir tank.

Fig 4: Installing Cap Of SST (0K585-E8100) On Reservoir Tank
Courtesy of HYUNDAI MOTOR AMERICA
Make sure the check valve (A) is closed and connect SST (09580-3D100) (A) to the adapter (B).

Fig 5: Connecting SST (09580-3D100) To Adapter

Courtesy of HYUNDAI MOTOR AMERICA