Repair Procedures: Replacement

CAUTION:

NOTE:

When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
When removing the interior trim pieces, use a plastic panel removal tool not to damage the surface.
Take care not to bend or scratch the trim and panels.

Remove the cowl side trim. (Refer to Interior Trim - "Cowl Side Trim ")
Using a screwdriver or remover, remove the crash pad side cover [LH] (A).

Fig 1: Locating Crash Pad Side Cover (LH)
Courtesy of HYUNDAI MOTOR AMERICA
After loosening the mounting screws, remove the crash pad lower panel (A).

Fig 2: Locating Crash Pad Lower Panel
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the diagnosis connector (A) and various connectors (B).

Fig 3: Disconnecting Diagnosis Connector (1 Of 2)
Courtesy of HYUNDAI MOTOR AMERICA

Fig 4: Disconnecting Diagnosis Connector (2 Of 2)
Courtesy of HYUNDAI MOTOR AMERICA
Install in the reverse order of removal.
Information
- Make sure the connector is connected properly.
- Replace any damage clips.