Repair Procedures: Replacement

CAUTION:

NOTE:

When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
When removing the interior trim pieces, use a plastic panel removal tool not to damage the surface.
Take care not to bend or scratch the trim and panels.

Using a screwdriver or remover, remove the center lower panel assembly (A).

Fig 1: Removing Center Lower Panel Assembly
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the A/C & heater controller connectors (A).

Fig 2: Disconnecting A/C & Heater Controller Connectors
Courtesy of HYUNDAI MOTOR AMERICA
Lower the steering wheel.
Using a screwdriver or remover, remove the steering column shroud upper panel (A).

Fig 3: Removing Steering Column Shroud Upper Panel Using Screwdriver
Courtesy of HYUNDAI MOTOR AMERICA
Using a screwdriver or remover, remove the cluster fascia upper panel assembly (A).

Fig 4: Removing Cluster Fascia Upper Panel Assembly Using Screwdriver
Courtesy of HYUNDAI MOTOR AMERICA
After loosening the mounting screw, remove the center fascia upper panel assembly (A).

Fig 5: Removing Center Fascia Upper Panel Assembly
Courtesy of HYUNDAI MOTOR AMERICA
Install in the reverse order of removal.
Information
- Replace any damage clips.