Repair Procedures: Removal

Information 

• Mark all wiring and hoses to avoid mis-connection.
• Turn the crankshaft pulley so that the No. 1 piston is at top dead center.

1. Remove the timing chain

   (Refer to Timing System - "TIMING CHAIN ")

2. Remove the fuel pump adaptor (A).
   Fig 1: Removing Fuel Pump Adaptor

   Courtesy of HYUNDAI MOTOR AMERICA
3. Remove the E-CVVT assembly plug (A).
   Fig 2: Removing E-CVVT Assembly Plug

   Courtesy of HYUNDAI MOTOR AMERICA
4. Disconnect the intake E-CVVT assembly (A) and exhaust CVVT assembly (B).
   Fig 3: Disconnecting Intake E-CVVT Assembly And Exhaust CVVT Assembly

   Courtesy of HYUNDAI MOTOR AMERICA

   Information 

   When installing the CVVT assembly bolt, hold the camshaft with a wrench to prevent the camshaft from rotating.

   Fig 4: Installing CVVT Assembly Bolt

   Courtesy of HYUNDAI MOTOR AMERICA
5. Remove the camshaft.
   1. Remove the front camshaft bearing cap (A) with the upper bearing (B).
      Fig 5: Removing Front Camshaft Bearing Cap With Upper Bearing

      Courtesy of HYUNDAI MOTOR AMERICA
   2. Remove the camshaft bearing cap (A) in the sequence shown.
      Fig 6: Camshaft Bearing Cap Bolts Loosening Sequence

      Courtesy of HYUNDAI MOTOR AMERICA
   3. Remove the camshafts (A).
      Fig 7: Removing Camshafts

      Courtesy of HYUNDAI MOTOR AMERICA
   4. Remove the exhaust camshaft lower bearing (A).
      Fig 8: Removing Exhaust Camshaft Lower Bearing

      Courtesy of HYUNDAI MOTOR AMERICA