Removal and Installation

WARNING: This page is about a different variant/trim than selected.

Remove the engine room under cover (A).
Tightening torque:

7.8 ~ 11.7 N.m (0.8 ~ 1.2 kgf.m, 5.7 ~ 8.6 lb-ft)

Fig 1: Removing Engine Room Under Cover
Courtesy of HYUNDAI MOTOR AMERICA
Install in the reverse order of removal.
Information

Check the tightening position.

Fig 2: Engine Room Under Cover Bolts Tightening Position
Courtesy of HYUNDAI MOTOR AMERICA

NOTE: The front under cover is assembled to be located at the top of the bumper.

Fig 3: Locating Front Under Cover To Bumper Top
Courtesy of HYUNDAI MOTOR AMERICA