Transaxle Mounting Bracket

WARNING: This page is about a different variant/trim than selected.

Remove the air duct.
(Refer to Intake and Exhaust System - "AIR CLEANER ")
Remove the battery and tray.
(Refer to Engine Electrical System - "BATTERY ")
Remove the air cleaner assembly.
(Refer to Intake and Exhaust System - "AIR CLEANER ")
Install the jack to the edge of transaxle.
Remove the Engine Control Module (ECM).
(Refer to Engine Control/Fuel System - "Engine Control Module (ECM) ")
Disconnect the ground cable (A).
Tightening torque:

10.8 ~ 13.7 N.m (1.1 ~ 1.4 kgf.m, 8.0 ~ 10.1 lb-ft)

Fig 1: Disconnecting Ground Cable
Courtesy of HYUNDAI MOTOR AMERICA
Remove the service cover (A).

Fig 2: Removing Service Cover
Courtesy of HYUNDAI MOTOR AMERICA
Remove the transaxle mounting bracket bolts (A).
Tightening torque:

88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)

Fig 3: Removing Transaxle Mounting Bracket Bolts
Courtesy of HYUNDAI MOTOR AMERICA
Remove the transaxle mounting support bracket (A).
Tightening torque:

58.8 ~ 78.5 N.m (6.0 ~ 8.0 kgf.m, 43.4 ~ 57.9 lb-ft)

Fig 4: Removing Transaxle Mounting Support Bracket
Courtesy of HYUNDAI MOTOR AMERICA
Remove the transaxle mounting bracket (A).
Tightening torque:

68.6 ~ 88.3 N.m (7.0 ~ 9.0 kgf.m, 50.6 ~ 65.1 lb-ft)

Fig 5: Removing Transaxle Mounting Bracket
Courtesy of HYUNDAI MOTOR AMERICA
Install in the reverse order of removal.